Ten key points of safe operation of steel bar sleeve wire rolling machine are introduced by China Power Tools Exporter.
Ten key points of safe operation of steel bar sleeve wire rolling machine are introduced. Different from other wire rolling machines, we can not operate and use the original method in the operation, the safety operation of the steel wire nesting machine, mainly pay attention to the following ten points:
1. The equipment must be in charge of by special personnel, and the operators must be on duty with certificates.
2. Before using the silk sleeve machine, check whether the four pieces are installed in order, whether the connection is firm, whether the lubrication of each operating part is good, and whether there is any leakage of electricity. Only after the empty test run is confirmed to be correct, can the machine enter the normal operation.
3. When processing the steel bar of the China Power Tools, must use the steel bar cut by toothless saw, do not use the steel bar cut by the cutting machine, in order to prevent unqualified wire sleeve and damage to the blade.
4. Steel reinforcement must be firmly clamped when the wire is covered.
5. The flow of coolant must be guaranteed when the wire is set, and the coolant should be replaced in time. In winter, when the wire is set, attention should be paid to heat preservation and water discharge at night to prevent damage to the pump motor.
6. During the operation of the machine, it is strictly forbidden to sweep the debris and dirt on the blade. If the working condition is not good, stop the machine immediately for inspection and repair.
7. It is strictly forbidden to operate in excess of the equipment performance requirements to prevent accidents.
8. Strict implementation of the cross operation law, to ensure that the machinery in good working conditions.
9. It is strictly prohibited to carry out China tools maintenance without stopping during the operation of machinery.
10. The work is finished, to power off and lock the brake box.
没有评论:
发表评论